郴州附近有没有服务

National Service Hotline: fifteen billion eight hundred and sixty-six million eight hundred and eighty thousand two hundred and eighty-eight

Safety operation process of shot blasting machine

Date: January 5, 2020 18:53 popularity:
1. When you go to and from work, you must not tilt the stick.  
2. Reflect on whether the motor and roller table are stuck, whether the bearing is short of oil, whether the drive chain is suitable for tightness, and whether the hydraulic oil in the two trolley hydraulic stations is available. If there is any problem, it should be handled in real time. Whether the height of the cleaning system is suitable for the height of the thrown components.  
3. Reflect on the dust accumulation level of the dust collector, and if there is too much dust, it should be cleared in real time.
4. Before work, check whether the fixed bolts of shot blasting device and motor are loose (especially the bolts on the end cover of shot blasting motor) and whether the motor bearing is short of oil. If there is any problem, it should be tightened or refuelled in real time; reflect on the wear condition of the blade, guide sleeve, shot wheel and other vulnerable parts of the shot blasting device and the wear condition of the chamber lining plate. If the wear is severe, it should be replaced in real time; reflect that the sealing curtain should not be missing The scene of falling or damaged.   
5. Task order:
(1) Start the dust removal system in the following order: start the system manually
(2) Separator on
(3) Elevator on
(4) Lateral spiral escort on
(5) Longitudinal spiral conveyor on
(6) Roller system on
(7) Cleaning system on
(8) Shot blaster on
(9) Loading workpiece on feed roller table
(10) When the workpiece moves forward and reaches the set position, open the shot gate
(11) Shot, liquidation begins
(12) When the workpiece is cleared, the shot gate is closed
(13) Unloading the workpiece on the delivery roller table
(14) Repeat steps 9, 10, 11, 12 and 13
(15) If you are ready to abort the mission, go to step 16
(16) Shut down the shot blasting machine → shut down the purging system → shut down the longitudinal spiral conveyor → shut down the transverse spiral conveyor → shut down the drawing machine → shut down the separator → shut down the dust remover → shut down the roller table, and the task of the whole machine is terminated.  
Stop the machine in reverse order, and after closing the shot blasting machine, let the shot material recycling system and dust removal fan run continuously for 5 minutes, so as to clean up the remaining shot and dust. After shutdown every day, turn on the soot blowing pulse for 15 minutes. Finally, cut off the main power supply.  
6. It is strictly forbidden to open the access doors when the shot blasting machine is working, and all personnel shall keep a certain interval with the shot blasting machine as far as possible.  
7. After each shift, cut off the main power supply, and clean the shot blasting machine and surrounding fields. The shot blasting machine body and maintenance channel and the channels around the shot blasting machine are strictly prohibited to avoid slipping!